Placing the new iCatalyst and Easy Lifting System in 10 minutes

Placing the Easy Lifting System is a one time affair. You put two collars into place and bold them tight. You then connect the wingnuts and rods. The Easy Lifting System is now in place. You don’t need to adjust it or remove it when you don’t use it. So if you want to run the iStill 250 without the catalyst/gin head, you can just leave it on.

But if you do want to insert the catalyst AKA gin head, you now just turn the wingnuts and thus lift the main column. Placing (or re-placing) the catalyst is perfectly possible within 10 minutes.

Here’s an example of how the Easy Lifting System is installed and how the iCatalyst can be added:

foto 2Install the collars …

foto 3

Add the lifting rods …

foto 4

Raise the column & insert the iCatalyst …

foto 5

Tighten the bolds …

foto 1

Ready to go!

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s